on 08-15-2013 7:03 PM
Dear All,
We upgraded the system from BW 7.0 to BW 7.3.
We see that Request updated to data targets check mark in data source(PSA) is missing for the previous loads which are done before upgrade to 7.3. However, these loads are already updated to InfoCube.
After upgrade the loads which have taken place to cube level from data source are with check marks.
Please kindly suggest any steps to taken to get these check marks back to original position.
Will these effect the data in any manner.
Regards,
Sandeep.
Thank you All,
Raised an issue to SAP.
Thank you all again for your kind help.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear All,
Thank you for helping me with suggestions. However, the data has been uploaded to targets before upgrade and I see the updated to data targets (tick mark at datasource) is enabled after upgraded data loads but missing for all the requests before upgrade. And this is happening for all the datasources.
Kindly suggest.
Regards,
Sandeep.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sandeep,
Is this happens to only one data source or all data source?
if its happen to all data sources then upgrade may not happen properly.
Have you performed after the upgrade check list?
as stated by Murali, if request are transferred to target without missing, then reinit and continue the delta loads.
One more thing are sure your checking present requests or old request(at PSA) which you gave old date while refresh psa requests.
Pls check the link.
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sandeep ,
If all the data has been updated and you only need to get that check mark in place then run the DTP between data source and the info provider with init without data transfer mode.
Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sandeep,
Does the data load is of Full load or the Delta?
If this is of Full load then you can ignore this but if this is Delta, then you we need to check why this issue has come. If you are sure that the data is loaded properly before upgrade and there are no further loads which are sent to PSA, then you can perform the init-withou data transfer at the DTP level which will solve the issue.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.