Skip to Content

Setting up automatic transfer order creation for a delivery note

Ladies/Gents,

when adding the message type WMTA to a delivery manually and then afterwards running RSNAST00 a transfer order is created and printed.

What customizing steps will I need to carry out to get WMTA assigned to the delivery note automatically.

Our Z delivery note is using output determination procedure V1REL1 and the output type is LDRL.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Aug 15, 2013 at 06:10 AM

    Not sure if I understand your question correctly. But if you just want to determine output WMTA automatically during delivery creation, use VV21 to maintain condition record for WMTA accordingly.

    Add comment
    10|10000 characters needed characters exceeded

  • Aug 17, 2013 at 09:20 AM

    Kenneth,

    Our Z delivery note is using output determination procedure V1REL1 and the output type is LDRL.

    In the AS-IS scenario, are users entering output type in the delivery pertaining to this above delivery type?

    If yes, then YB Wang has suggested ONLY a valid condition record has to be maintained. In the output condition record (VV21), time = 4 (immediate), this means that when delivery is created (and a valid condition record is found) TO shall be created automatically.

    One question -

    and then afterwards running RSNAST00 a transfer order is created and printed.

    Why are users running this program?

    If there correct program and smartform program are assigned to the output type, then this manual action is not needed.

    Former Member could you please comment / confirm this last point?

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 16, 2013 at 05:55 PM

    Hi

    Assign output type to determination procedure in below path.

    LE-->Shipping-->Output control-->output determination-->Maintain output determination for outbound deliveries-->Maintain output Determination procedure.

    Assign output determination procedure in below path.

    LE-->Shipping-->Output control-->output determination-->Maintain output determination for outbound deliveries-->Assign output determination procedures.  (Tcode: V/71).

    Then maintain condition record as YB Wang said above.

    Regards,

    Krishna.

    Add comment
    10|10000 characters needed characters exceeded