Repost function Error Invalid selection

[Former Member]

Hi Folks,

I have a repost function.Every week it is executed via process chain.Planning sequence fails when run via process chain and error is "Incorrect Counterpart selection.".

I tried executing the sequence manually and it is successful,no errors.

Another thing i observed is counterpart is neither used in Fields to be changed or in conditions.

Kindly advice.

Thanks

[cornelia_lezoch]

Hi,

when executing the sequence in RSPLAN - do you enter any variable values?

Do you run your sequence in process chain with a variable variant?

regards

Cornelia

[Former Member]

Hi,

The planning function has no variables and no variable variant is present in process chain.

Thanks

[Former Member]

Hi Kitu,

Try to check the filter you are using when runing from PC.

Hope it helps.

[Former Member]

hi,

which filter because i just give Planning Sequence name

[cornelia_lezoch]

there is a filter used in the planning sequence. Usually the filters are defined including some variables.

[Former Member]

Hi,

Go the the modeler (tcode rsplan), edit the planning sequence you will get the technical name of the filter, in the same interface go to filters tab and check what's exactly in the filter.

Hope it helps.

[michael_devine]

Hi,

can you put up a screen shot of the error and perhaps the associated error codes. This will help to find the solution.

Regards,

Michael

[Former Member]

Hi,

These are the message no's i am getting:

RSPLF114

Message no. RSPLS411

Diagnosis
Errors messages occurred when you executed the sequence &V1& (&V2 & ).

Procedure
Analyze the log.

Kindly advice.