Skip to Content

CPS and x.509 Certificate Logon

Hi,

we are using the integrated version M33.85-65736 on NW 731 SPS7 and we have set up this AS Java to accept certificate logon. It works without a problem with NWA but unfortunately we need to enter the username and password for the scheduler although we are already logged in into the AS Java.

The same applies to another system where there are no certificates. If you log on to NWA you still need to authenticate again if you want to access the scheduler.

I checked the installation and security guides but I couldn't find anything.

Is this behaviour "by design" or are there configuration settings that need to be changed?

Regards

Andreas

Add a comment
10|10000 characters needed characters exceeded

Related questions

1 Answer

  • Best Answer
    Posted on Aug 11, 2013 at 09:37 PM

    Hi Andreas,

    Please have a look at the section "Basic Password vs Ticket Authentication" in the release notes for your version (in the documentation).

    This basically boils down to the following issue:

    There are two primary authentication systems on Netweaver, container based authentication, and programmatic authentication. SAP CPS uses container based authentication and I assume your certificate login uses programmatic auth. You can configure NetWeaver to use login tickets which should solve your problem. Please consult SAP support for the configuration instructions.

    The complete instructions can be found here: http://help.sap.com/saphelp_nw73/helpdata/en/4d/a5ddc832211dcde10000000a42189c/content.htm

    To configure SAP CPS to use logon tickets proceed as follows:

    1. Open Visual Administrator on the global server.
    2. Navigate to ''config > services > security provider''.
    3. Locate the following component:
    4. Switch to edit mode, on the right-hand side and select the ''Ticket'' template.

    Thanks,

    HP

    Message was edited by: h. Carpenter I added link to SAP help and instructions to configure SAP CPS for logon tickets.

    Add a comment
    10|10000 characters needed characters exceeded

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.