Skip to Content
avatar image
Former Member

Post Installation PI 7.31

Hello,

I installed SAP NW PI 7.31. I read the installation guide e follow the post installation.

Are there not specific for PI?

In my installation there are no users called PI*

there are no RFC to communication to stack java.

What else I can do?

Thanks!

Fernanda.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Jul 23, 2013 at 05:33 AM

    Hi Fernanda,

    Please refer to the following SAP Note. It describes the post-installation steps:

    https://service.sap.com/sap/support/notes/1548120

    and to the following discussion:

    http://scn.sap.com/thread/3391438

    Best Regards

    Harald

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Harald,

      Thank you for your help.

      I can't access nwa. Do you think can I access sld/run?

      Best regards,

      Fernanda.

  • Jul 23, 2013 at 05:52 PM

    Hi Fernanda,

    The install process should be as follows:

    1. install the system
    2. apply the latest SP stack
    3. run the post install Configuration Wizards

    Have you installed a dual stack or single stack PI? You should be able to access the nwa with the J2EE_ADMIN user. If not, check if the java engine is running.

    Regards

    Mark

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Fernanda,

      This could be the same issue as in note 1817869 Deadlock between AS Java session management and WD Runtime. Check if you have the patches mentioned in that note. Also check if you have all the latest patches for the Java components as documented in note 1794179 Importing AS Java Core patches for NetWeaver 7.1 or higher.

      Regards

      Mark