cancel
Showing results for 
Search instead for 
Did you mean: 

Loading JPY from BW cube to BPC

Former Member
0 Kudos

Hi all,

When we load JPY value from BW to BPC using standard package it multiplies the value by 100. Why does it do that and is it correct?

Please let me know.

Thanks.

Accepted Solutions (0)

Answers (3)

Answers (3)

Former Member
0 Kudos

Hi Devang,

Please check you transformation file and conversion file. That is not the default behavior.

Regards,

Kalyan.

Former Member
0 Kudos

Hi all,

I have no routine in any transformation and conversion file while loading data from BW. Also, I dont have anything in my default logic.

Thanks,

RamanKorrapati
Active Contributor
0 Kudos

Hi,

Please check this. may be useful.

http://scn.sap.com/message/11135003

Thanks

RamanKorrapati
Active Contributor
0 Kudos

Hi Desai,

while loading data from BW cube to BPC, if you didn't applied any conversion on JPY, it need to come as  bw cube.

But JPY have issue. So please check at BW side. Actually this value will/need to multiply by 100.

for ex: Take INR, 100 Paisa = 1INR, like that for JPY also 100xx = 1JPY, for that some where its multiply by 100 at bw side.

BW cube may have the value with 100 multiply??

Please recheck bw transformation from source to target bw cube. like start/end/expert routines.

Thanks

Former Member
0 Kudos

Hi Devang

It is not correct , there must be logic doing this calculation..

Check whehter there is any logic written in->

1)Transformation file/BADI-Routine

2)Conversion file

3)Default logic/BADI

JAck