Adding Spool List recipient

[Former Member]

Hi Team,

When setting up a user to receive emailed reports the "Spool List Recipent" is not retaining the email addres

It is saved as part of the SM36 set up. But when going back to check in SM37 the error is No Spool List recipient.

Could you please help me on this.

Regards

Raghu

[laurie_mcginley]

I'm running into the same issue.  When I change a job and add the spool list recipient, it uses that information for the next run, but subsequent releases (daily periodic job for example), the recipient information is no longer there.

We are SAP ECC 60. EhP6.  This functionality has worked in the past so I'm not sure what has changed.  What needs to happen to get the recipient to stay in the job description.

Thanks

Laurie McGinley

[david_liu1]

Hello,

Have you checked the SAP note 1810625?

Regards,

David

[laurie_mcginley]

Hi David,

I  did see that note yesterday, however I'm under the impress that since we are at SAPKB73105, and the note referenced (1673444) states it is corrected in 73103, that it note 1810625 didn't apply.  We have not implemented 1673444.

I wonder if I should take this up with SAP Support since it very much sounds like the issue in 1810625.

Laurie

[Former Member]

Thanks for your valuable suggestions

Furtherance all the reports printed to a particular printer. But few of the customers didn’t receive those reports. Even though I didn’t set them to print, but still we are getting prints. We set them only to receive mails.

In the successful job log I found “Error sending data (2)” Message no. PO780

Laurie , did u face this issue in your tricky. Does all this issues may helpful in this note 1810625

I really appreciate your help in advance

Regards

Raghu

[laurie_mcginley]

No, not something we've delt with.

I implemented that note, but we still have the issue.

Laurie

[laurie_mcginley]

SAP support directed us to do the following with corrected the problem.

1125583 - BCS: Report to correct number range objects 

Execute the report RSBCS_NUMBER_RANGE in your system in client 000 firstly with activated 'Test' flag(flag on selection screen) after program start.