Problem in triggering MATMAS IDOC through BD10 transaction

[Former Member]

Hi,

My scenario is to trigger an IDOC(MATMAS)in BD10 and store it as an XML file in the physical directory.

I have created a logical system for this and also created partner profile for the logical system defined.

Further i've have configured XML Port has my reciever port of the outbound message type(MATMAS). But when i trigger the IDOC, it says that "1 Master IDOC setup for the message type MATMAS" and "0 Communication IDOCs generated" and the outbound IDOC is not recieved at the concerned directory. Please help me out in solving this issue.

[Former Member]

Hi,

While doing configuration u must take care of creation of Distribution model. Here you need to give message type,sender & receiver.

At the same time you need to generate partner profiles. Results should give 'SYNCH' along with all info.

Check all the inbound/outbound parameters are correct or not.

If you satisfy with this pls close this issue and allocate some points.

Regards

KER.

[Former Member]

One additional Info:

I had the same problem with an existing ModelView (BD64) for MATMAS. It turns out that the ModelView EndDate was expired.

You can check that by double-clicking on the ModelViews Name. A window appears where the shorttext and StartDate /EndDate can be modified. If the current date isn't in that timespan, the modelview isn't taken into account and no communication IDoc will be generated.

[Former Member]

Peter is right, you must set up distribution model (BD64) with source logical system (your sap), the target logical system (your xml file) and the message type MATMAS.

When you run BD10, the program look for an entry for MATMAS into the distribution model.

Regards

PabloX.

[Former Member]

Hi

Please check your partner profile . Seems no destination could be found for MATMAS idoc so no communication idoc created .

Cheers.

[Peter_Inotai]

Did you also create/generate a distribution model?

Peter