Skip to Content
avatar image
Former Member

Create specification without component lower and upper limit

Hi,

I'm using the function module C1F5_SPECIFICATIONS_MODIFY to create a sepcification. In my component table, there is an average value but no upper or lower limit. These two values are intial ( 0.0000 ). If I call the function module, I get the error "The average value does not lie between the lower and upper limit".

How can I call this function module and pass only the component average value?

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Jul 01, 2013 at 07:09 AM

    The solution is to pass the value -1 to the component COMPLOWDEC and COMPUPPDEC of structure RCGAPIVP. This is described in the documentation of ESECOMPNUMDEC.

    Add comment
    10|10000 characters needed characters exceeded

  • Jun 29, 2013 at 01:40 PM

    Dear Christian

    e.g. check may be:

    http://www.consolut.com/s/sap-ides-zugriff/d/e/doc/E-C1F5_SPECIFICATIONS_MODIFY (I found by hazard only german link but english link should be available as well)

    Check:

    http://www.se80.co.uk/sapfms/c/c1f5/c1f5_specifications_modify.htm

    You need to pay attention here. You need to understand that this function module is used for any activity. Therefore you can update value assignment type of type "B" and "C". In "background" the same table is used "ESTVP). Therefore it is "tricky" how to poupulate the parameter "right" and there is a "tricky" add on to know: The "null" topic. (using CG02 you can maintain lower upper limit but you need not and how SAPsolves this is quite tricky

    Furtheron what is "tricky" is the "internal" handling of "values" if you have a component of Type C (check ESTVP table).

    I found no special link which is reallyrealted to your topic. You "play2 around

    C.B.

    Add comment
    10|10000 characters needed characters exceeded