Addition of new Attributes in Shuffler and to display data in SNP planning book

[Former Member]

Team - We have a requirement to add additional fields in SNP planning book shuffler for the below selections

- ABC code

- XYZ code

- Material type

- Product category

- Product Hierarchy

- Strategy group

- Purchasing group

- Procurement type

- Special procurement type

i.e we need the above in SELECTIONS and also in shuffler SELECTION CONDITION. Note that we are using standard SNP MPOS 9ASNPBAS.

BADI /SAPAPO/SDP_SELECTOR were used to implement this , however this will just help me to add the fields , i.e just to display.

Once i selected the above in the shuffler and if i want to load the selection then what should be done to acheive this?

NOTE: we managing to pull the data for the above attributes from MATLOC and our customized BW table ZMATNR.

FYI - I do refered all the discussion in our SCN post but still i stuck up. Any help on this would be highly appreciated.

http://scn.sap.com/thread/1739726

Cheers

Ganesh K

[Former Member · Accepted solution]

Hi Ganesh,

If you are making use of /SAPAPO/SDP_SELECTOR BAdI In APO, it is not only to add the fields in the dropdown of shuffler but also we can filter out the Hit List on basis of input criteria given in the Shuffler selection. According to your requirement, you can make use of below methods in the same BAdI.

PRODUCT_VALUE_LIST 

LOCATION_VALUE_LIST

LOC_PROD_VALUE_LIST  - Modification of the Location Product Hit List

RESOURCE_VALUE_LIST

LANE_VALUE_LIST

PPM_VALUE_LIST

DP_CHAR_VALUE_LIST

Use of any of the above method is depend on your 'Show' condition in shuffler popup, if the Show = APO Product Locations then you can use method LOC_PROD_VALUE_LIST to filter product locations.

Regards,

Saurabh

[Former Member]

Hello Saurab - Apologies for the late response. Tried but still it did not helped my requirement.

It seems more shuffler attributes are not supported by SNP.

[Former Member]

Closing this thread

[Former Member]

Hi Ganesh,

In the PB you have something called as "header Information settings" in the top of the

planning book. You choose the characteristics you want to drill down there.