on 05-14-2013 1:33 PM
Hi
I've founded this two fileds but I don't find corresponding fields into the form: SWeight2 and SWght2Unit
where an end user can edit it? Thanks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Ok but into this folder I find only the field "Weight" linked to the physical fields
Hi Feliciello,
These are system fields that are not exposed in the B1 client. The user cannot edit these fields.
Regards,
Johan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Feliciello,
As far as I have been able to tell, these fields remain blank.
Possible explanations for these fields may be, that they are only visible and/or used in a certain localization, or the system uses them as temporary fields for calculations, or they are fields that were used in a very early version of B1, and have been depreciated since then, or they could be fields that are used only under certain circumstances (first some other field must be used, for example).
Regards,
Johan
Ok
I need two fields into OITM table:
- net weight
- gross weight
So I have use Weight1 and SWght1Unit for net weight
and a NEW one for gross weight, haven't I?
It would depend. If you need different brutto and netto measurements for purchase and sales, then you may have to set up a userfield.
If however, brutto and netto measurements are the same for both purchase and sales, you could use the purchase tab (BWeight1) for brutto and the sales tab (Sweight1) for netto
User | Count |
---|---|
91 | |
10 | |
10 | |
6 | |
5 | |
5 | |
5 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.